PE14-Hex: 14-inch Penetrator with 1-3/8-inch Hex neck tapped for 1/2-inch -13 thread hardware
- Product Overview
Product Overview
14" Penetrator anchor with 1-3/8" hex neck drilled and tapped for 1/2"-13 thread fitting.
Typically used to secure tents, canopies, RV awnings, dogs, deer stands and hunting blinds, outdoor sculptures, small aircraft, greenhouses, domes, carports, shelters, generators, and air conditioners. For temporary and permanent structures. Easy to install and remove.
Typically used to secure tents, canopies, RV awnings, dogs, deer stands and hunting blinds, outdoor sculptures, small aircraft, greenhouses, domes, carports, shelters, generators, and air conditioners. For temporary and permanent structures. Easy to install and remove.
Type
Penetrator
Length
14"
Head
1-3/8" Hex
Flange
N/A
Flights
2-1/4"
Weight
1.76 lbs
Material
356 Aluminum
Part
PE14-Hex
Ultimate Holding (vertical)
2,500 lbs*
Lateral Holding
230 lbs*
Base Plate Hole
1-1/2"
*Technical Products, Inc. (TPI) conducted instrumented pull tests on all products provided to us in a Class 2/3 Soil (medium sand/gravel). After the anchor was installed as per instructions an increasing load was applied orthogonal to the long axis of the anchor until the anchor failed as demonstrated by a sudden decrease in load bearing capacity. Each anchor was tested three times and results averaged. The test results are summarized in the table below. It is our professional opinion that in more cohesive and dense or better compacted soils this load bearing capacity will increase.